|
|
Build Your Online Product Catalogs?
| Product Name: |
Debugging method of manual spot welding machine
|
| Supply Ability: |
10000 |
| Related proudcts |
welding machine, spot welding machin, |
| Specifications |
Customizable |
| Price Term: |
FOB |
| Port of loading: |
gz |
| Minimum Order |
1 |
| Unit Price: |
360USB |
|
Installation, adjustment and use of mask spot welder
I believe that many customers will pay special attention to the common problem when purchasing mask spot welder: how to debug the ultrasonic mask spot welder?
Why do you pay so much attention to the debugging of mask spot welding machine? Because if the debugging is not good, it will directly lead to the situation that the mask welding is not firm, the ear belt will fall off, or the mask will be welded and melted off. How to debug the mask spot welder? Today, tengdi electromechanical editor gives the specific debugging and using methods:
1. Check whether the 220 VAC power supply is normal. If the power supply voltage is lower than 200 V, the ultrasonic force will be affected. If the power supply voltage is lower than 180 V, the power supply of the power regulator can be increased: 100W / set.
2. Check that the air source pressure is 5-8KG / cm2, and ensure that the air pressure behind the regulator is 3-5kg / cm2 (air pressure affects the flatness of welding).
3. Welding machine column installation
Note: when locking the thread of column, screw the screw in place first, and then lock it in a diagonal way to ensure that the column is vertical to the platform of flat car.
4. Initial adjustment of cylinder stroke
(1) Cylinder stroke adjusting screw: the pressing depth of the welding head can be adjusted (it has been adjusted at the factory, only fine adjustment can be made).
(2) . manual pneumatic button: press and hold the air cylinder to press down, and then it will pop up when it is released (do not step on the foot switch during debugging).
(3) Pneumatic throttle valve: adjust the action speed of the cylinder (it has been adjusted before delivery, so it can not be adjusted).
(4) Gap test paper: during rough adjustment, the pressing depth of the welding head shall be subject to the free dragging of the paper.
5. Welding test the parallelism between welding head and stainless steel plate
The parallelism between the welding head surface and |
| Company: |
Dongguan tengdi Electromechanical Technology Co., Ltd
|
| Contact: |
Ms. Manager Huang |
| Address: |
5 / F, lianchangsheng commercial building, Wanjiang District, Dongguan City |
| Postcode: |
523000 |
| Tel: |
86 0769-23174896 |
| Fax: |
86 0769-22775303 |
| E-mail: |
|
|
|
|
Home
